Oven door off for access to the bake element
Last updated:
Case Study · Oven Repair · Seattle, WA
The bake element in this Dacor ERSD30S dual-fuel range in Seattle had burned out. The metal sheath had split open at a bend, so the element could no longer heat. We replaced the bake element and ran the oven until the new element glowed red. Real photos from the job below.
What happened
The range
A Dacor ERSD30S dual-fuel range in a Seattle kitchen: gas burners on top, an electric convection oven below. The rating label inside is dated January 2000.
The diagnosis
The bake element, the heating loop on the oven floor, had burned out. At one of its bends the metal sheath had blistered and split open, leaving a visible break in the element. An element in that condition can no longer heat.
The fix
With the oven door off for access, we removed the old element and installed a new one, then ran the oven. The new element glowed red all the way around and the oven temperature climbed on the display. The door went back on and the repair carries our 90-day warranty.
Real photos
Oven door off for access to the bake element
The old element, burned through at a bend
Close-up: the sheath split open where it burned out
Rating label: model ERSD30S, dated January 2000
The new bake element, ready to install
Test run: the oven heating on the new element
Glowing evenly all the way around
Door back on, oven heating again
Why choose us
Older high-end ranges
A range built in 2000 can still be worth fixing when the failed part is a single element. We tell you plainly if it isn’t. See our repair or replace guide.
One technician, start to finish
The same owner-technician finds the fault, explains what failed, and does the repair. No call center and no subcontractors.
90-day warranty
WA Contractor #ACEAPAS774K6. We’re an independent repair company, and this repair is backed by our 90-day warranty. See our oven & range repair page for more.
Questions
Yes — this case study is a Dacor dual-fuel range in a Seattle home. We also serve nearby Shoreline, Lake Forest Park, Mercer Island and Bellevue.
Often, when the rest of the range is in good shape and the failed part is still available. This range’s label is dated January 2000, and replacing one bake element got the oven heating again. If a repair isn’t worth it, we say so. See our repair or replace guide.
It depends on the model and the part. We check the oven first, then give a clear price before any repair begins.
Yes, Ace Appliance Service LLC is licensed and insured to work in Washington State. WA contractor license #ACEAPAS774K6.
On a dual-fuel Dacor range the oven is electric, so a failed bake element is one of the most common causes. A failed broil or convection element, a temperature sensor, the control, or a bad wiring connection can cause it too. On this range the bake element had burned through, so it was replaced.
A working bake element glows red when the oven heats. If it stays dark, we check it with the power off. Visible damage, like the split sheath on this Dacor element, a blister or a break, is a clear sign it needs replacing.
Ready when you are
Call now for the fastest response, or send us a few details and we'll call you back within one business hour.
(425) 533-0823 Call Now · Same-Day ServiceMon–Fri, 8am–6pm