Last updated:

Case Study · Sub-Zero Refrigerator Not Cooling · Edmonds, WA

Sub-Zero repair in Edmonds: a 1997 501R not cooling, compressor not running.

This Sub-Zero 501R built-in refrigerator in an Edmonds home, built in March 1997, wasn’t cooling at all, and the compressor wasn’t running. We replaced the cold control (the refrigerator’s thermostat), the door gasket and a light bulb, and cleaned a condenser packed with dust and lint. Real photos from the job below.

  • Location: Edmonds, WA
  • Sub-Zero 501R built-in refrigerator, built March 1997, R-134a
  • Symptoms: not cooling at all, compressor not running
  • Repair: new cold control (thermostat), door gasket and light bulb
  • Maintenance: condenser cleaned
  • Diagnosed & repaired by Max, EPA Section 608 certified
5.0 Google Rating Licensed & Insured 1-Year Sub-Zero Warranty Owner-Operated

What happened

From a warm Sub-Zero to a cooling one again

The problem

This Sub-Zero 501R in an Edmonds kitchen wasn’t cooling at all. The compressor wasn’t running, so nothing was moving heat out of the refrigerator. The rating plate inside the door dates it to March 1997, running on R-134a.

What we found

The cold control is the thermostat that tells the compressor when to run. It sits behind the rear cover panel inside the refrigerator, mounted on the evaporator coil, and it was the reason the compressor wasn’t starting. The door gasket had also lost its seal along the door edge, and the condenser was coated in dust and lint.

The fix

Over two visits, we replaced the cold control, the door gasket and a light bulb, and cleaned the condenser coil so the system can shed heat properly. No sealed-system work was needed. Sub-Zero repairs carry our 1-year parts and labor warranty.

Real photos

This job, start to finish

Stainless Sub-Zero 501R built-in refrigerator under maple cabinets in an Edmonds kitchen

The Sub-Zero 501R in the Edmonds kitchen

Sub-Zero rating plate reading model 501R, built March 1997, refrigerant R134A

Rating plate: model 501R, built March 1997, R-134a

Hand pulling back the old door gasket on the Sub-Zero 501R refrigerator door

The old door gasket, pulling away from the door

Sub-Zero 501R with the evaporator cover removed, showing the evaporator coil, cold control wiring and light bulb

Evaporator cover off: cold control, wiring and light bulb

Cold control (thermostat) held in hand in front of the Sub-Zero 501R evaporator coil, wires still connected

The cold control, the thermostat that switches the compressor on

Sub-Zero 501R condenser coil and tubing coated in dust, lint and cobwebs before cleaning

Condenser coated in dust and lint before cleaning

Sub-Zero 501R condenser coil after cleaning, fins visible again

The same condenser after cleaning

Sub-Zero 501R refrigerator with the door open after the repair, shelves and crisper drawers in place

Back together after the repair

Why choose us

Why Edmonds homeowners call Ace Appliance Service

Older Sub-Zero units welcome

Built-in Sub-Zero refrigeration often lasts 20–35+ years, so a 1997 unit is often worth fixing. We repair older Sub-Zero models like this 501R as well as current ones, with genuine Sub-Zero parts. See our Sub-Zero repair page.

One technician, start to finish

The same owner-technician finds the fault, explains what failed, and does the repair. No call center and no subcontractors.

1-year warranty

WA Contractor #ACEAPAS774K6. Sub-Zero repairs carry our 1-year parts and labor warranty. See our refrigerator repair page for more.

Questions

Sub-Zero repair in Edmonds: FAQ

Do you repair Sub-Zero refrigerators in Edmonds?

Yes — this case study is a Sub-Zero 501R in an Edmonds home. We also serve nearby Lynnwood, Mountlake Terrace, Shoreline and Mukilteo.

Is a 1997 Sub-Zero worth repairing?

Often, yes. Built-in Sub-Zero refrigeration commonly lasts 20–35+ years, compared with 10–15 for a standard refrigerator. This 501R needed a cold control, a door gasket, a light bulb and a condenser cleaning — not a sealed-system repair. See our repair or replace guide for how to decide.

Are you a Sub-Zero authorized service provider?

No. Ace Appliance Service is an independent repair company, not a Sub-Zero factory-authorized servicer. If your Sub-Zero is still under its factory warranty, contact Sub-Zero first. Outside that warranty, we repair it with genuine Sub-Zero parts, and Sub-Zero repairs carry our 1-year parts and labor warranty.

How much does it cost to replace a Sub-Zero cold control?

It depends on the model and what else the unit needs. We diagnose first, then give a clear price before any repair begins.

Are you licensed and insured?

Yes, Ace Appliance Service LLC is licensed and insured to work in Washington State. WA contractor license #ACEAPAS774K6.

Common Sub-Zero refrigerator problems

Why is my Sub-Zero not cooling and the compressor not running?

A compressor that won’t start can come from a failed cold control (thermostat), a failed start relay or overload, a wiring or power problem, or a failed compressor. On this 501R it was the cold control. On a Sub-Zero freezer in Everett it was the start relay and overload — see the Sub-Zero freezer won’t cool case study.

How can I tell if my Sub-Zero door gasket is bad?

Look for tears, flattened sections or spots where the gasket pulls away from the door. A gasket that doesn’t seal lets warm, humid air in, so the refrigerator runs longer and can build up frost or sweat around the door.

How often should a Sub-Zero condenser be cleaned?

We clean it once a year for our maintenance customers. A condenser clogged with dust and lint makes the compressor work harder and run hotter. See our Sub-Zero maintenance guide.

tion>

Ready when you are

Sub-Zero not cooling? Let’s take a look.

Call now for the fastest response, or send us a few details and we'll call you back within one business hour.

(425) 533-0823 Call Now · Same-Day Service

Mon–Fri, 8am–6pm

Submitting this form sends a request — it doesn't reserve a specific appointment time. We'll call or text to confirm scheduling.

Call Now Text a Photo